Stubby Post - show ip protocols

Thu, 10 Jun 2010 00:00:00 +0000

I’ve seen and used the command before, but I’ve never really seen any use of the show ip protocols command until tonight while reading up for my ROUTE test. There’s a lot of good information in the output, and, from the way the book is reading, this is a great candidate for use in a lab question.

To check it out a bit, I set up a small network with four routers connected only to a single Ethernet segment. I set up one router to run EIGRP, OSPF, and BGP to each one of the other routers just so I could see the output for the different routing protocols. Here’s what puked out after struggling with GNS for a few minutes.

Show on Aaron's Worthless Words

Stubby Post - show ip protocols